• Easy-to-Build • All Wood Hand-Launched Glider• 2-Channel Radio Required(mini servos recommended)BEFORE STARTING CONSTRUCTION, READ THROUGH THIS INST
1—1 2. Based on the servo location, cut the pushrodguide tubes to fit. Leave enough room for the servooutput attachment. Use 1/16" wire for this.
Airfoil - A curved structure designed to create lift bythe reaction to air moving over its surface.AMA - Academy of Model AeronauticsA.R. - Aliphatic
FLIGHT LOGStarted ConstructionFinished ConstructionFirst FlightCOMMENTSDATE
PROTECT YOUR MODEL.YOURSELF & OTHERS BYFOLLOWING THISIMPORTANT SAFETY PRECAUTIONYour Skeeter is not a toy, but a sophisticated workingmodel that f
Please inventory and inspect all parts carefullybefore starting to build! If any parts are missing,broken or defective, or if you have any questionsab
DIE-CUT PATTERNS4
BUILD THE WINGU 1. Start the wing by placing the wing portion ofthe plans on the building board. Cover the planswith wax paper or plastic wrap. This i
Q 11. Carve and sand the trailing edge sheeting toaccept the upper trailing edge sheeting.Q 12. Lay the wing back down on the work surface.Apply thick
Q 20. Joining the wing panels: Using the sametechniques outlined in steps 16 thru 19, prepare, fitand glue the two wing panels together using thedie-c
Q 2. Glue the 1/4" sq. top and bottom longeronsinto place.Q 3. Drill or cut and file a 1 /2" hole in the center ofF3. This will allow the pu
Q 21. Tack glue the hatch/canopy block into placewith about 4 drops of CA. This will hold it in positionwhile the front of the fuse is being shaped.Q
Comments to this Manuals